This adds a driver for the ST M95xxx series SPI EEPROMs.
The driver has been tested with the M95M01 EEPROM, but should
work with other chips from that family.
SPI-EEPROMs from other vendors from the families AT25xxx, 25AAxxx,
25LCxxx, CAT25xxx & BR25Sxxx should also in the same way.
This is the radio found in NXP Kinetis KW41Z, KW21Z. Only 802.15.4 mode
is implemented (KW41Z also supports BLE on the same transceiver).
The driver uses vendor supplied initialization code for the low level
XCVR hardware, these files were imported from KSDK 2.2.0 (framework_5.3.5)
This adds a driver for the SPI based AT86RF215 transceiver.
The chip supports the IEEE Std 802.15.4-2015 and IEEE Std 802.15.4g-2012 standard.
This driver supports two versions of the chip:
- AT86RF215: dual sub-GHz & 2.4 GHz radio & baseband
- AT86RF215M: sub-GHz radio & baseband only
Both radios support the following PHY modes:
- MR-FSK
- MR-OFDM
- MR-O-QPKS
- O-QPSK (legacy)
The driver currently only implements support for legacy O-QPSK.
To use both interfaces, add
GNRC_NETIF_NUMOF := 2
to your Makefile.
The transceiver is able to send frames of up to 2047 bytes according to
IEEE 802.15.4g-2012 when operating in non-legacy mode.
Known issues:
- [ ] dBm setting values are bogus
- [ ] Channel spacing for sub-GHz MR-O-QPSK might be wrong
- [ ] TX/RX stress test will lock up the driver on openmote-b
The AT24MAC is an EEPROM that provides unique ID functionality.
On one address it provides normal AT24xxx EEPROM operations, but
on a seperate i2c address a read-only EUI-64 and a 128-bit ID are
provided.
This adds a simply driver for this chip.
The INA219 has the exact same interface as the INA220 (including values and
semantics of the configuration register). Thus, this driver can be used for
both. The ina220 has been renamed to ina2xx to reflect this and pseudo modules
for the ina220 and ina219 have been added.
Added driver for the WS2812/SK6812 RGB LEDs often sold as NeoPixels, which due
to their integrated RGB controller can be chained to arbitrary length and
controlled with a single GPIO.
The Atlas Scientific pH OEM sensor is a small circuit to be embedded in
end products to measure the pH value with any commercially available pH
electrode
Rename TMP006 to TMP00x
Add TMP007 sensor support to TMP00X
Change uint8_t reg to uint16_t
Add to doxygen documentation group
Expose compile time configurations
Move defines from .c to .h
Change double to float, because double is not needed
Add TMP007 register information
The LTC4150 is a coulomb counter (a.k.a. battery sensor or bidirectional
current sensor) that is used in the MSBA2 board and available for little money
as easy to use break out board.
Alexandre Abadie